Establish a performance baseline. Measure your results. Improve your racing setup.
Derby Dust® Benchmark Companion Cars are purpose-built performance reference vehicles designed to provide a consistent, measurable standard for pinewood racing.
Unlike traditional completed race cars, Benchmark Companion Cars are developed specifically for performance comparison, track evaluation, and tuning reference. Each car is professionally assembled, configured, and individually track-tested to meet or exceed an established minimum performance standard.
Our Benchmark Companion Cars are available in three performance categories determined by wheel weight. Each category offers two performance levels:
-
Benchmark: Meets or exceeds the established minimum performance standard for its wheel-weight category.
-
Beyond Benchmark: Meets a higher, separately established performance standard for the same wheel-weight category.
Every vehicle is tested before shipment using the same controlled track configuration to provide a consistent basis for performance comparison.
Standard Performance Configuration
All Benchmark Companion Cars share the following specifications:
-
Three-Wheel Rider: Configured with one raised front wheel to reduce rolling contact.
-
Rail-Riding Alignment: Tuned to maintain controlled contact with the center guide rail.
-
3° Rear Wheel Camber: Both rear axles configured with 3 degrees of negative camber.
-
Adjustable Front Steering: Bent front-right axle permits fine steering adjustments and alignment tuning.
-
Graphite Lubrication: Wheel and axle contact surfaces prepared using graphite lubricant.
-
Primer Gray Finish: Uniform appearance across all performance categories.
-
Individually Track-Tested: Every car must achieve its designated minimum performance standard before shipment.
Controlled Track Testing
Each Benchmark Companion Car is tested on Derby Dust's dedicated performance testing system.
Testing Equipment
-
Track: 35-foot aluminum BestTrack
-
Starting Ramp: 26-degree incline
-
Starting Gate: Jukes Engineering ESS (The Edge Super Starter)
-
Timing System: Custom TimeStopper single-lane timer
-
Lubrication: Graphite
Testing is performed using a consistent track configuration and starting system to establish repeatable performance measurements.
Your car's performance classification is determined by actual track results, not simply its components or assembly specifications.
Important: Preserve Your Benchmark
DO NOT REMOVE OR REPOSITION THE WHEELS OR AXLES.
Each Benchmark Companion Car is individually assembled, aligned, lubricated, and tested as a complete performance system.
Removing, loosening, bending, repositioning, or replacing any wheel or axle changes the tested configuration and immediately voids the car's original benchmark certification and performance standard.
Even small adjustments can significantly alter steering, wheel contact, alignment, and recorded track performance.
The adjustable front steering axle is provided for controlled tuning experiments. However, any adjustment from its factory-tested position invalidates the original benchmark results until the vehicle is retested.
Understanding Benchmark Results
Benchmark Companion Cars are intended to establish a reference for evaluating racing performance, not to guarantee identical times on every track.
Track length, slope, surface condition, starting mechanisms, timing equipment, and environmental factors can affect recorded race times.
The published benchmark represents the minimum performance level achieved under Derby Dust's specified testing conditions.
Built for comparison. Verified by testing. Engineered for consistency.
Shop Derby Dust® Benchmark Companion Cars today. Choose your wheel-weight category and performance level, and purchase a track-verified reference car to establish your performance baseline.