Pinewood Axle Drill Guide – H03S

$14.95

The Ultimate Drill Guide without breaking the bank

Convertible Model.  Use the key for BSA slots for perfect axle alignment.  Omit the key if you are using a block without slots.  Slightly over sized because we know there are rarely any blocks perfectly 1.75″ in width.  Make sure to register the same side against the Guide when not using key for drilling.   Use pin vise for years of use.  Can be used with drill with ease.   $19.95 compare to $150.

  • Drill 3 degree rear camber
  • Drill 0 degree
  • Drill High Wheel
  • S- Steer positive camber with toe in
  • #44 Drill bit included

With the power of 3d printing we mated the two popular pinewood derby tools and came up with the perfect tool to pre-drill axle slots for axles.  I promise you will 100% accurately correctly drill you axle slot every single time, perfectly.  We are the first to market.  I am 100% certain others will copy, but just let you know we were the FIRST.  We are so confident that these are successful, we have purchased at total of 12x 3D printers to make inventory for 2021 Derby Season because we have to print of 20,000 hours of inventory!

If your slot is not perpendicular to your body, its not going to fix that.  You will need to drill it without the key to fix this error.

Derby Dust Drill Guides for BSA Axle slots are the perfect and only tool you should now use to drill axle slots.  Made of environmentally friendly PLA plastic, this tool can be used over and over.  We have no problems drilling 25+ cars on a single jig!   Included is a #44 drill bit for perfect axle install.  Drills a perfect .086″ diameter hole for your BSA axle every single time!

[widget id="block_widget-4"]

Copyright © 2012-2021 Machine Envy, LLC.  All Rights Reserved.  Derby Dust® is a registered trademark of Machine Envy, LLC.

Machine Envy, LLC is neither affiliated with nor endorsed by the Boy Scouts of America. Pinewood Derby® is a registered trademark of Boy Scouts of America.

Derby Worx® is a registered trade mark of Derby Worx, Inc. Rail Rider™ is a registered trademark of Derby Worx, Inc.

Awana® is a Registered Trademark of Awana Clubs International. Machine Envy, LLC is neither affiliated with nor endorsed by the Awana Clubs International.